Search results

Thanks for the info Terry

Thanks for info, much appreciated - is a solenoid coil replacement a possible DIY job or better done by an engineer?

Hi, I have a Worcester Boiler Heatslave 20/25 that started locking out yesterday. I can reset the boiler and it works for a short period of time (seems to be getting shorter every time I reset). I've checked the water pressure and all good, any ideas on what the problem maybe? Cheers, Steven

Thanks all - just an update - temp fixed now applied and working, thanks for everyone's input, much appreciated. I think I'll install one of the smart stats at some point but will just keep the temp fix for the time been.

Thanks for the additional info all, much appreciated. I can see where the programmer wires go into the main PCB board as follows, but not sure exactly what I need to change to do a temp fix, happy for any input.

Cheers for the info Ian - understood, will give that a go.

Cheers - comfortable with electrics so happy to hear any suggestions you can give on a temp fix.

Thanks for the help - will take a look into the replacement control panel. In the meantime is there any way of manually triggering this - I suspect not but worth asking. :)

The manual diverter valve lever is not floppy and is currently set in the up position.

Cheers - I've attached a picture of the control panel and normally the light circled in red would be on. Yes, currently cold water comes out of the hot water tap when turned on.

Yep Ian - it does, all good on that front.

Thanks - will allow the boiler to cool, presuming a few hours should be ok...then I'll try the procedure as per the instructions to pump water to the heatslave tank.

Apologies Chris - should have been hot water - edited

Thanks Ian - just filled up to 1.5 bar, no luck. Control Panel - Power Light - On, Lock Out - Off, No HW Light - when I press the button does not come on, although it is set to on. Cheers

Thanks Ian, tried that, no luck unfortunately. There was no click when I pressed it so presume it had not tripped, any other ideas? Cheers for the help.

Hey there, I have a boiler (Heatslave 20/25) that had low pressure. I topped the pressure back up to 1 bar using the external filling pipe but the hot water still won't come on. Do I need to reset anything? Thanks for any help