Search results

It was a wheel bearing. Apparently it was only gone on one part if that makes any sense

It won't let me attach a MP3 file

They still haven't found the problem yet . They've told me to book it in next week and they will investigate further. I made a recording of the noise from my foot-well I'll attach it

I think they are still investigating. They are keeping my car tonight. He said he's going to remove the drive shaft to check it

The mechanic said the wheel was harder to spin than the good side when jacked up

What's the most expensive?

Hi again I eventually got back to the garage and they said it's either a driveshaft or a wheel bearing. Hopefully I find out tomorrow

It is like a scraping noise . I will check them backplates I got a stone lodged in there a few years back

Good morning Ive recently had a noise from my car that sounded like brakes catching on whilst I was driving along. I went to my local garage he suggested changing all pads and discs plus when checking he also found leaking shocks so I also had them changed. Unfortunately I still have the sound...

Thanks again I really appreciate it

Thanks Ian , I'm warm again, so far anyway . There was more than a bit of grit in there, I've also changed the diaphragm as it did look baggy. Thanks again

Just checking so I obviously drain down the boiler but I can leave the water on ?

Is it possible to leave the valve in the boiler and just remove the four screws micro switch and diaphragm? Then how would I clean the holes ? Something like a pin ?

Light came on again and boiler went off . The pin is down now

Hi again just re read your reply. I need to take out the small diaphragm to unblock the holes . Can I do this with the valve in situ ?

I can't really see in the hole as the pin never goes completely in . Here's a photo of before and after I turned the heating on today

I suppose that would explain why it's starting working again when I reset it .

Hi I just noticed that my baxi 105e had stopped working (central heating) , the 60 light was flashing (fault on pump or low pressure). My water pressure is 1.2 bar . I reset the boiler and it's now been on for 2 hours so I'm guessing the pump isn't broken. Any idea what the problem could be ...

Possibly a newer model with brass replacing the plastic part ?

I also can't understand it . I'm thinking I didn't put enough paint / primer on . I originally thought it was coming from inside the sill but not sure how likely that is . What to you think about squinting waxoyl into the sills through the drain hole ?