Search results

hi all, i have a diplomat adp 5426 range cooker. as soon as the main is turned on the fan oven fan starts to run. even with the switch/stat at off position. the only way to stop this is to turn off at main again. any ideas?

wm52 uses hot and cold feed

hi all. i have just replaced the carbons on a customers aeg72600 lava. the machine now spins o.k. but now after filling and agitating maybe three times there is a constant clicking noise from some sort of drive behind the soap disp. i have never come across this before so any input from other...

yes

if you look at your four tagged unit there should be two brassy coloured connections and two silvery colour. connect the two grey wires anyway to the brassy tags and two whites to the silvery tags. should solve problem

check the spray arms are noy blocked with food debris

the small hose goes from the switch to a sausage sized rubber hose. remove white top of hose and clean gunge from pipe. hope this helps

your brushes may have melted holder therefore keeping the carbon off the comm.if so this will indicate a pump fault

i have seen this before. it could be that the heat sensors on top of your oven near the cooling fan have packed up. when the oven turns off if you leave it on will it come back on of its own accord after a while?

the module on your machine will have burnt out. is expensive part. probably a reason for board failure. i.e heater/motor

check where the motor wires are tied up. could be rubbing and shorting

i have foundthe cause to be mainly a faulty pump. pumps are quite cheap so change it. if it does not cure it will be your module board. not cheap. good luck

if your machine has brushes it wont have a capacitor. must test motor. probably the comm burnt. if so you need new motor

a sure way to tell if it is your module is as follows. re-connect board so machine is ready to use. remove lid. you will see a round object,this is the pressure switch. remove the tube from the bottom of switch and find a piece of tube you can attach and blow down.set your machine on a programme...

i think it will be your module on the bottom left hand side of your machine from the back. unplug from power, remove screws that hold plastic case and then remove board and check for burn marks. good luck