Search results

So, Handymanjo.... I don't know where to start on thanking you for your help over the last number of hours. You have successfully help me complete the last few sections which has enable this install to be completed. I have never used forums previously, however, I would now highly recommend these...

Sorted that also. I found the section on Users.

sorry, yes, the master code works. Need to enter new user code and replace the other code so there not factory.

I can't find that, looking for it as we speak.

I have actually cleared the end user code and now I can't turn it on?

Yes, I have everything now working. Only last thing seems to be codes. I need to enter (end user) code, and change Engineer code along with Master Manager code.

When I turn the alarm off I receive this message (see picture from app). ?

I think I have solved that. I had it set to number 5(Tamper) instead of 6(Intruder).

So I have done that and I now have this. (See picture) I think that's good? I can now set the alarm and exit and everything is fine. However, when the alarm is off and I walk past input 1 (Dinning room) the alarm goes off? (See picture).

OK, sorry, yes I have then I'll go and put them on the four unused ports.

Could you tell me which of these are 2.2K resistors?

Sorry, forgot to say, yes, they are all 360 PIR's and they all light up.

Ok, let me go do that.

I have as follows:- Input 1 - PIR Input 2 - Door Contact Input 3 - PIR Input 4 - PIR

Yes, however, it may not be right then?

This is what's displayed.

It's input 1 i'm using, input 2 is the door contact from earlier.