Worcester heatslave 12/18 coming up with error a0 809 which is saying thermal store sensor which one is it and is there anyway of testing which one it is
Riello burner going into lockout press it it goes green and red and then back to a flashing red have changed burner but used same control and does the same thing im thinking controller is the fault ? Or what else could it be
Hi burnerman got a problem with a greenstar heatslave with riello burner the boiler pump runs but the burner wont kick in its flashing red if i reset it it flashes red and green and then goes back flashing red ive another burner but the control had gone on that so ive swapped controller over...
Riello burner going into lockout press it it goes green and red and then back to a flashing red have changed burner but used same control and does the same thing im thinking controller is the fault ?
Its getting 240v all the time just tested fan starts up
And runs for say 15 seconds then electrodes start runs for second or less then fan stops and the electrodes still spark for a few seconds then stops but sometimes the fan kicks back in
Ok ill take it back out and check its got a constant 240v what could be causing the 240v to not be there ? If i reset it it resets and starts but does the same ive took the pump off the side and ran it it does the same without pump on it
Burner runs for 10 seconds starts sparking then motor seems to stop and the sparker keeps running but fan and motor stopped what could it be ? Ive took the pump off and run it it still does the same
Theres power to the yellow connector so they are both calling from the programmer and yes have put piece of wire in just to make sure the stats arnt goosed