Search results

Thanks all for your replies, much appreciated.

Would it be possible to chip out to brick, seal with SBR, fill with sand/cement mix, finish with filler?

Fire sits in open fireplace, plaster seems pretty sound around affected area, no other parts are affected.

Chimney breast has inset electric fire, cowl on pot

Any idea what could be causing this on the plastered surface? It's gradually appeared over time. It's on a chimney breast wall which has no other issues. What's the best remedy to sort it? Thanks in advance

Any idea what could be causing this on the plastered surface? It's gradually appeared over time. It's on a chimney breast wall which has no other issues. What's the best remedy to sort it? Thanks in advance.

Thanks everyone for your replies, much appreciated.

Many thanks for that information, much appreciated.

Got ya, it's the symbol, lines following the 4 5v. Sorry about that, thanks again.

Or is that It in the model number? Thanks for your reply.

Can see the 4.5v but no DC.

Hi All, a small query, could this be removed and replaced with a 3 pin plug as we only require the steady mode, I can't see anything about it being DC output, many thanks in advance.

How can I run this cable directly down into conservatory? It's gonna be for fibre broadband, less bends the better. As it is now it goes under the flashing and down between house and added conservatory. Many Thanks Brian.

OK, thanks very much, advice much appreciated.

With the tiling I was just concerned about the tile adhesive sticking to the wood, many thanks for your reply.

Hi folks, can you offer any advice on the following. I'm planning on tiling kitchen floor but there is a trench containg 2 x 15mm copper pipes, the top of the trench is finished off with a wooden board. What's best to protect these pipes so I can remove the wood and cement over before tiling...

Thanks for your reply.

Thanks for your reply.

Hi all, I looking to fit a battern light onto a ceiling that's been cladded with upvc, I've attached the type of lamp I'm planning on. Which is the best way to connect to the mains? I was thinking of a lighting wago box pushed up behind the ceiling behind the light. These fittings have flex pre...

I've just removed a very old cooker back box from a kitchen wall. The wall is a Thermalite cavity structure, on removal of the box I'm left with a gaping hole that goes right into the cavity. How do I make this good please? Was thinking of patching in with Thermal Insulation Board, leaving...