Search results

So just to finish this off. My confusion was that there are different sizes etc so thanks for the help. Turns out i was being stupid - got some taps, used the existing fittings and new washers and viola that was it. I couldnt quite get the nut underneath tap quite tight so need to sort that but...

Thanks - or could I just bolt the flexi onto that angled join?

Its a combi but the pressure is rubbish - but noted. So can I just remove that vertical pipe from that angle and replace that section with flexi and bolt it straight on?

Hi Folks, Ok so I want to try and do this myself but need some help - or its time to call a plumber, but I am determined I can do this. Basically the bathroom wash basin taps are shot. Need replacing. However its hard pipe into them - I measured across (no calipers) and its seems to be 15mm...

So just to finish this off mostly. It came today after a few delays. The wiring was like for like but the back plates still needed swapping. Got that done and switched to gravity mode - works perfectly. Too late tonight to get the thermostat wiring sorted but its bumped up to max to not...

@stem Thankyou - here are the pictures. What I meant was from my limited understanding. The wiring means that the heating call only operates the pump, but the hot water has to be on to produce the heat to be pumped. So assuming my assumption is correct, then gravity mode will in effect...

Thanks for all the help so far. I have taken the unit off to examine the back plate and the wiring is as suspected missing the key element of heating triggering the boiler unless the water is set to on. Oddly that back of the unit is set to "pump" rather than gravity mode. So I assume I...

Thankyou - I guess the next step is to take the controls off and have a look at the wiring to see what its doing. Going on this basis looks like a dual channel order for the Hive is the first step - then when I get stuck a further post asking for help (inevitably!)

Hi, Sorry this must of been done a thousand times. I have a LP722 and a drayton thermostat. Initially I was going to order the dual channel Hive and crack on. However I have an oil fired boiler with separate water and heating controls. But importantly no hot water cylinder - only super heated...