Search results

Hi everyone, just to share an update. All wired in as to @sparkymarka photos and programmed and it works perfectly. I can now control the garage door with the “ii” button on my pyronix keyfob, on the home control app and with a doorbell on the inside of the garage. Many thanks @sparkymarka ...

Thanks ! Ordered this one - https://www.ebay.co.uk/itm/266466985862?mkcid=16&mkevt=1&mkrid=711-127632-2357-0&ssspo=VM-u9OccQ5W&sssrc=4429486&ssuid=vLCexlOYQia&var=&widget_ver=artemis&media=COPY

One last question - where’s the best place to buy the IS M12? There’s a CEF (listed on IS website as a distributor) local to me but they don’t have this item listed.

Incredible work, thank you @sparkymarka ! Will by the delay and give it a go. I’ll report back the outcome!

Yes maybe, can’t seem to find any recommendations in their install manuals. Do you think that Amazon one’s worth a go or would you suggest the plaxton?

Thanks! I’ve had a look at programming and doesn’t look too difficult. I just need to get the correct relay. Worth asking pyronix? Maybe a 1 Channel relay like the one below? With the garage motor connected to COM and NO? https://amzn.eu/d/37ccLjw

Brilliant, thanks! Would a relay like this be ok...

Thanks @sparkymarka please could you advise any further on the wiring? I’ve attached my garage door manual. I assumed it would be figure 11, terminal 21 signal Chanel 1 impulse to Enforce PG1?

Hi all, is it possible to use the PGM output to open and close my electric garage door from my mobile app?