Search results

  1. C

    Texecom alarm won’t sound when armed

    Thanks all Temporarily turned the resistors off to get working and will rewire over the weekend
  2. C

    Texecom alarm won’t sound when armed

    So the PIRs are currently wired with 6 cores. With Green, White, Blue, Yellow being wired into A, B, C and D respectively. The zones are currently wired as normally closed as I was getting a tamper fault on EOL with the above set up. At the panel, green and white going to the zones, with...
  3. C

    Texecom alarm won’t sound when armed

    I’ll have to look at the jumpers on one of the PIR tomorrow but don’t think I changed any from the box. Is there any other cause of why I wouldn’t be getting any resistance when closed?
  4. C

    Texecom alarm won’t sound when armed

    The 04K680 or that they under resistors?
  5. C

    Texecom alarm won’t sound when armed

    Capture P15 PIRs. When I activate the PIR, and review zone status it goes from 000R to 04K680 so believe it is resistors?
  6. C

    Texecom alarm won’t sound when armed

    A correction to my original post - when I do the walk test via Engineer Utils it comes up with an error message of *NONE* but they have an LED on the PIR when walking past.
  7. C

    Texecom alarm won’t sound when armed

    All active zones just have Area as A. in zone setup via the keypad. Any other advice?
  8. C

    Texecom alarm won’t sound when armed

    I’ve recently installed a premier elite 24 system and upon entry to the property there is no entry tone and the alarm won’t sound. I get an exit tone, and when entering it says Area A arm etc but there is no sound on entry. I have no door contacts and have the PIR on the entry hallway as...
Back
Top