Search results

Okay took the flylead/link wire off and the prong side had charring on the wire poking out. I have replaced with a new 2.5mm crimped ring end wire. Using a heat resistance 2.5mm that is identical to the new feed cable that I fitted last time around. Time will now tell. Note of interest was...

Resolved: the thermostat was clicking when the temperature was rising (on) but not when falling (off). This was intermittent. New rod has a distinct click both directions, old rod when working had a weak click on the falling direction . Thanks to those who helped problem solve. I believe as a...

Note most say that the normal working temps for inlet though is 65c

90degrees and 3bar

That’s a good idea, so mix cold in with hot out via TMV?

Yes, tank is heated in off peak.

Heating 65 and below means no hot water for multiple showers. Whilst the ideal would be a bigger tank, this is not affordable at the moment.

Auto range was on and apart reads 1.blankblankblank the immersed is on just now and at 54c it is doing a lot of clicking.

So what is your conclusions? Faulty?

Turning from 70 is 0 ohm Click heading colder is: there is no click 25 is reading 122.1kohm Heading hotter to just before click is out of range then 0, 0.1,0.2,0.3 at click

I think it is light green - didn't know that they had standardised an aging process. Thanks for all the pointers though, Tap water measures same as the Eddi and water stat on the pellet boiler so all is reading the same. The thermostat is pointing to 60c as just as you had suggested I...

Because the invention of forums is for asking questions. Hence that is what I was doing. Calling a sparky or plumber on a sunday at 11.15pm is a bit overkill - don't you think. But thanks for the useful insight into your knowledge of this topic.

https://www.myenergi.com/product/eddi/ The sensor is a pocket in the tank - not at the immerser- slightly lower- where the box is on the left. It is showing as lower than the cut off on the thermostat of the immerser but the immerser is cutting out and tripping. The wood pellet burner is...

It is a yellow copper cylinder circa 2000. similar to https://mcdonaldwaterstorage.com/products/vented/vented-cylinders/ https://www.screwfix.com/p/tesla-dual-safety-thermostat-11-/48571 The cylinder is heated with electricity and wood pellet boiler. The temperature of the hot water...

Yip emersion element - thought the two "water cylider and immersion were interchangeable". Soft as they come water- NE scotland. I have noticed though that it is a 14" Tesla element with an 11" rod - rather than 7" - will that matter?

Hi everyone, I have an electric hot water heated unvented cylinder. The reset button keeps popping on the thermostat. I have tested two screws reading is 14ohm I took the thermostat out (Tesla) and put it in a tall jar filled with water at a temp of 60 c. I put a meat probe in to get a...