Search results

Oh wow. Feel like a complete tit! I'm one of those people I literally grabbed it out of the box and chucked it in with the fixings already on. Lesson learned check everything

Hope this is useful. Photo taken with the system off. Was told my the guys at Heatmiser to open the flows up and the mixer temp gauge fully open to start with then to adjust it once the system starts to heat up and circulate

New system and in the process of commissioning it. I've completely bled all of the circuits a month ago or so Would it be worth doing it again?

Hi all looking for a bit of help with my UFH I have a three zone system downstairs covering about 35m² and radiators upstairs on a separate hive system There are two two port valves installed. One just after a tee going upstairs for the rads and another for the in the UFH cabinet. It's all...

Awesome ok that makes sense to me. I think that may be the best route to make things simple Also just a thought but if I have electric actuators on each zone with an individual thermostat for each zone/room. Would I need a two port valve on the flow pipe into the UFH system or would the...

Not sure if it's worth mentioning too but I've got electric actuators also on each individual zone on the UFH manifold

I haven't actually installed the Port valve yet so I can put it wherever it needs to go potentially. Can you setup Hive to control different zones in the UFH system? If I wanted to use the Heatmiser stats I'm guessing I would have to install two zone valves? Not sure I can return the stats now...

Hi all first time posting here and I apologise if this has already been covered but I am looking for some advice on an underfloor heating system. It's a 3 zone wet ufh system with Heatmiser (UH4) wiring centre and 3 heatmiser WiFi hardwired Neostats The wiring centre is installed with power to...