Search results

LOL yeah whatever !!! :D

Hey there, yes I do carry out a boiler repair service, Gas safe number is 305919 Mckenziewood Ltd, check it out my son, Thanks for your sarcastic comments /help

Does anyone know which digital room stat is compaitible with the vaillant 828E turbomax?? At the moment I have a very old mechanical 'Switchmaster' room stat which has seen better days and want shot of it now, I have a cable with a live, neutral and earth, which cable am I going to have to...

Hey, Vaillant 828E Turbomax plus, 7 yrs old, pressures ok (1.5bar at cold) i've looked in past posts and can't seem to find the answer. My boiler runs ok when CH is called for at the room stat but when any taps are turned on the green flow light does not flash and neither does the boiler...

will this be a standard 40mm 1.5" straight connector to join the copper to plastic? cheers

Alright guys, no I have not done it yet, yeah looking at the pic its not very clear but the part you can see is the bath trap going into the copper pipe run to the stack, was thinking to run plastic right upto the stack and leaving the connection but dyno rod have said the copper run is blocked...

Hi guys I need advice on how to join a 40mm 1.5" plastic waste pipe to a cast iron stack, the stack runs through the bathroom and I will need to replace the exsisting waste from the bath which is copper as you can see from the pic, would you think its better off to run the new plastic waste...

hi Richard, I know its confusing but let me brief you.. Techflolw twin impellor positive head type fitted next to the hot water tank sitting on the floor, 22mm hot feed to pump is taken off the hot feed pipe at the top of cylinder (and NOT a essex flange which is directly from the cylinder). I...

would not it be better to fit the hot supply from the cylinder to the pump through a flange as recommended by techflow?

Hey there, ive a Techflow branded twin impellor shower pump running the bathroom, gravity fed system, the pump has been replaced about a week ago and the problem is the pump just runs for about 3 secs and stops for 10 secs then back on etc... when there are no taps running anywhere, its...

nice idea tony will test this out and let you know, cheers

ha ha aha ha you have saved me from embarrassment !!! cheers :oops:

Hi mate yeah no hot water, tried turning taps on and checking boiler and the boiler is not heating water and neon is unlit when the taps are open

Hi all, I have a Worcester 35 cdi boiler fitted to the ground floor of my 2 level house, and when I run the hot water taps it runs hot on the this ground floor but when I open the hot taps on the next floor up thee is no hot water emerging, just cold, not even warm, this is baffling as the hot...

nice one guys thanks wil try these ideas out, thanks so much

cheers kevplumb, but whats a nvr on the mixer valve, cheers again

Hi mate, yeah its horsmann I think, looks as if its got limescale in and around the little lever. Yes there is a mixer tap to the bathroom basin, whats the procedure my man? thanks

Hi Seco, yes its a 3 port motorised valve but its navy blue in colour if that helps, probably stuck in neutral position I would think, do you agree? How do I clear the suspected air lock from the hot water pipework? Cheers mate