Search results

You can plastic push fit, some have service valves fitted, which fit straight on to the taps, you will need to continue the earthing by joining the hot and cold via earthing cable and earthing clamps. If you are using pushfit flexi's you won't need anything else, but if are using normal...

What you should do is repeat what LOAFER had posted earlier, but you shouldn't need PTFE the Olive will be enough

For the drainage the size of the pipe and trap has to be 40mm, the maximum distance is 3 metres from the stack and the gradient is 18- 45mm per metre

Without actually looking I can't tell exactly. I don't really recommend it, but you could fit a new self fitting one from B&Q and not use the existing one. Although you could do this it would reduce the flow/pressure, so really you would need a plumber to correct it

All above are correct, and easy job to do

Gate valves, need to be turned off and on every two or three months. Limescale may be onside stopping it fom moving, what you may need to do is tighten a little to dislodge the limescale, then try again to loosen the Gate Valve, if this don't work you may need to fit a new one.

Do you know if you have a one pipe system, this is when you have just one pipe going to the Radiator, which don't continue to another and one which leaves the Radiator?