Search results

Hi. your problem is probably caused by a blockage in the pressure system which tells the machine whether theres water in the drum or not. Its a piece of thin tubing which runs from the drum up to a circular switch unit usually located somewhere beneath the top cover. You need to drain the...

Could also be something as simple as a faulty door interlock - the interlock has an internal switch which supplies power to the machine. Other possibilities - faulty panel switch, break in wiring loom. Use a multimeter to check, with power off of course. Check out www.2ndwave.co.uk/manual.html...

Possibly a fault with the heater - not heating the wash water. Could be the element itself, the wiring to the element, thermal overload cutout or a faulty themostat. Check out www.2ndwave.co.uk/manual.html for info.

Indicates a short circuit on the motor drive board - probably requires replacement of board or "module" as its called. Check out www.2ndwave.co.uk/manual.html for useful info.

Possibly a fault with the door interlock. It has an integral switch which enables the various functions of the programme. If its burnt out or otherwise damaged could cause this problem. Check out www.2ndwave.co.uk/manual.html for useful info.

Hi. the tube leading into the drum from the wash compartment is probably blocked. Disconnect the power, remove the top of the machine and disconnect the tube from the dispenser and the drum ends, remove any crud with a piece of wire and rinse out. Check out www.2ndwave.co.uk/manual.html for some...

Could also be a faulty start capacitor if the motor is an induction type. Check belt. Possibly also could be the motor speed control board or "module". No way of testing other than replacement with known good unit. Check out http://www.2ndwave.co.uk/manual.html for useful info.

Hi Sleepyhead. Have added email to profile as requested.

Would have no problem paying for them, however I have approached several manufacturers who will only offer the manuals to their own approved service agents, which i am not. have done several online and ebay searches but can only find generalized manuals not the error code specific ones I`m...

Hi sleepyhead. Have gone into self employment repairing domestic appliances. I dont have access to the error codes and error light combinations on the latest microprocessor controlled systems which would save me a lot of trial and error on repairs. Have been following the various questions and...

Hi Sleepyhead. Would it be permissable to ask you to contact me directly? My name is Dan and mobile no. is **************