Search results

Cleaned out the pressure chamber and drained all the water from the waste pipe and pump hose, made sure everything was fully sealed when I assembled it all back and now it works Thanks for everything guys

I have already replace the pipe - got one from diy store 44p still no joy I've remove the whole pressure assembly and tried the old bicycle inner tube test in a bucket of water to see if any bubbles come out - no bubbles Haven't reassembled it yet - I can't understand what can be preventing...

I've changed the pressure switch and the hotpoint wma32 still just keeps filling. I've blown down the pressure chamber pipe and this will start the drum spinning, if I hold my thumb on the end the tube keeps the pressure switch activated and the machine continues through the cycle. Where...

What is it that trips the prewash light ?

Thanks breezer I've disconnected the tube to the pressure chamber - I guess as the drum fills up the pressure increases - I tried blowing into the pipe as the machine filled up and this did start the drum rotating...but what to check now - I guess the switch could be faulty or the pressure...

The machine keeps filling and then I get the flashing pre-wash light - what is supposed to turn off the water, is it timed or is there a sensor? Can I get a service manual for one of these?