Search results

On my sink basin, ive correctly assembled the pop up rods with the basin, when i push down on the rod behind the taps the waste plug pops up as normal, my problems is if i pulled the rod up shouldnt it close the waste plug? thanks in advance

ive just quoted a rear at £1200 materials and labour - specialist coloured render

how many sq metres?

whats on the bricks? i always give a good fungicidal wash scrubbing with a wire brush, try that

if there's no holes in the plaster board, just tile over it make sure you use plenty of pva before you tile though

best thing to do is work for a company while you set yourself up,. your gaining experience you dont have picking up tricks of the trade going to find out how to price up find out best suppliers and your getting paid whil e you learn and set up

cheers scotsman for the advice, ive taken it to a repair centre thanks anyway

dot and dab much quicker and easier, 9.5 is fine

thanks for the advice , drained all the water out again hopefully it'll be ok , water comes in when i turn the machine on now. the lower arm wash fixtures are these underneath the filter inside the dishwasher?

im a plasterer, mainly doing rendering & dashing, where are u based? 4 - 1 ratio with a good measue of feb mix

pushed the machine back bit of water came out of a hole below where the water supply hose is. carried out 2 cycles no problem tried a 3rd and the same problem started again. what do i need to take off to find the blockage? the back, inside, underneath? how do you reset the anti flood...

yeah a couple of scratch coats will level out, regarding mesh depends on what render your using. I use it every time with basecoat

has it been skimmed yet? is the board damp?

machine wasnt tipped on its side , there is a bit of water when you pull the filter out in the base - is this a blockage? does a blockage prevent water coming in?

no, took the hose off then turned the water supply back on and water came through fine - for some reason its not going into the machine

tap is turned on properly and there is no kink in the hose, its fitted exactly as it was before

never do work with a company that has approached you, just paint over it all - you can fill the cracks in by mixing a bit of water with cement into a paste and fill in the cracks with it using a paint brush

hi, i disconnected my dishwasher to tile my kitchen floor, after re connecting the dishwasher. i tried a cycle and no water enters the dishwasher, checked to see if its connected properly and it is, so any ideas on what could be the problem? Thanks in advance

if your pebbledash is loose, coming off (test with a lump hammer if it feels loose) best off hacking it off . If solid,go over it, a basecoat and finish coat will give you a good flat sound finish