Search results

ZWD1480 Washer dryer stops within 30 seconds of starting drying cycle - no error code displayed. Washing fine - no unusual noises. Entered diagnostic mode - no error codes on 10th setting - performed dryer test mode - heated up nicely based on the display and to touch on the top - no...

Looking to sound proof a bedroom floor against airbourne sound coming up from the kitchen below - voice mainly - and need some suggestions. I don't need to worry about impact noise in the bedroom being transferred downstairs. House is early 1980s - tongue and groove flooring on joists...

Had some damp problems in the loft - thought initially it was condensation but on further investigation I can see light at the apex of the roof in a couple of places. Obvious culprit is loose ridge tiles - does this sound right ? What ballpark should I be looking to pay to fix ? presuming...

Looking for a plastic blanking nut per the photo - got the M6 bolts. It is for a cot bed so need something I can take out rather than just glue something in - child might pull that off as well. It has an M6 thread (obviously) - shaft is 8mm wide externally and 16mm long. Any ideas on...

Fault - not cooling - compressor appears to be running - hot to touch, all other components working. Odd bit is the "at temperature" indicator on the temperature dial is not indicating a problem - just continuous light - this should (and has in the past) flashed if the temperature was too...

Solid timber internal panel door (about 15yr old) has a small split running across the centre of the hinge attachment point. Screws obviously do not now stay where intended so its either repair or replace. Any ideas on repair methods that are likely to be permanent as I don't want it coming...