Search results

I've just changed the bearings on my LG Intellowasher direct drive washing machine and the new bearing seal is squeaking against the shaft. Does anyone know if it wise to grease the part of the bearing seal that comes into contact with the shaft??? By the way, I've had to take it apart again...

I'm about to fit a stone resin shower tray onto floor tiles. Is it crucial to lay a bedding of cement down for the tray to sit on? It say's if the floor is uneven then the tray will crack. This is what it recommends, but I'm not keen to do it. If I ensure the floor tiles are laid well with...

I've just discovered that you need to remove the chrome plating from the copper pipe before fitting the speed fit joint, is this correct?? :shock: If so, then how do you remove the chrome plating without damaging the pipe?? :x Hope someone can help. Cheers

I'm about to buy 10 Pegler Terrier Ii Trv radiator thermostats from Screwfix.com. Can anyone recommend anything better or cheaper or are they all pretty much the same as far as quality goes. Would £4 thermostats from b&q suffice or is it, you get what you pay for? Thanks

How on earth do you get tiles off plaster board without destroying the plaster board? I've found that some tiles will come off easily where the plaster board was painted with a gloss finish. The others however, are not on a gloss finish and are very difficult to remove without pulling half the...

I'm currently fitting a 10.5kw shower where a 7.2kw shower used to be. The problem is the cable is 6mm and not 10mm. The cable run is around 10 metres or less and is not embedded in plaster board or insulation. The cable runs from the fuse box (obviously), under floor boards, through the waste...

Boiler make / model (gas or oil) Baxi Solo WM 70/40 PF SS Gas combi boiler what is / is not happening The pilot light light keeps going out which causes the main gas valve solenoid to shut off. How do I increase the pilot strength? has ANYTHING else been done / changed recently No...