Search results

Many thanks to you both, yes it is 230v and I am off to Maplins to sort this. Again many thanks, my first time on this forum and the v prompt replies are appreciated

Have just fitten 3x leds to new o/head light fitting that usually has e9 halogens. When fitting is switched OFF, the leds glow faintly and when switched ON all three glow normally; when I fit one halogen and 2 leds to fitting they all work fine but halogen is different colour. Anyone have...

sorry for lack of detail *does not spin *does not switch off *stays indicating 1 min then eventually starts again after about 10 minutes *happens every wash *thought this indicated blocked filter but empting pump is not running during pause and filter is clear

it does

Runs great till 1 minute left and then stops for up to 10 minutes. Filter is clear. Any suggestions?

sorry for lack of photo but yes, it is on the face and not the edge. many thanks for all replies

I need to rout beading in an mdf board to replicate existing beading and need a router bit with 1/4 inch shank. I have tried to find suitable bit but unsuccessful. Any ideas on finding attached bit. Cannot work out how to attach image but the bit is sharp point with radius inwards, cutting...

have an indesit d63 dishwasher that is intermittently tripping rcd. removed bottom plate and condition of wiring and components looks pretty clean. Any suggestions folks?

Can I connect a usb memory stick to my sony i-pod dock via adapter or lead. An i-PAD camera adapter is available but will this connect to an i-pod dock

many thanks for replies will spend easter w/e sorting system

i have a panasonic sa-pt470 which stopped working, first was blowing mains fuse in plug but now has blown F1 on chassis; fuse is colour coded and cannot identify rating. I think the problem started with overloading speakers, have sorted that but need rating of fuse. Any help out there? colour...

Refuses to start and indicates door not shut. Have accessed door interlock looks ok but can I short out leads (4 go to i/lock) to see if switch is the problem or pcb

Does anybody produce a self cutting valve for 15mm plastic pipes. Any advice would be appreciated

thanks rough i really needed a propriatory thinner, massive postage from renotex

anyone know how to thin renotex rollercoat. which is an exterior wall coating.

what can i use to thin renotex rollercoat (not renotex thinners)

Where can I purchase a coloured tyrollean render with sparkly bits in it. I have seen it and am quite impressed by effect

thanks Garfeild Does this mean it would not happen if my exp tank was below c/w tank and were the tanks fitted incorrectly 25 years ago Can we prove coil is leaking or just change the tank and hope it cures it. Tank is about 5 years old or less. I know this means not a lot but a bit unexpected