Search results

I will be tiling the bathroom. I want to tile inder the pedastal on the sink, with the sheet of ply and then the tile thickness this is likely to raise the floor approx 2 cm will there be enough `play` to do this or do I need to reposition the sink and pedastal. The water pipes are the rigid...

My washing machine ocassionaly doesnt empty, I have stripped it down to check for kink in tubes and that the pump rotates freely all of which is ok. It might run ok for a month and then not empty a couple of times then is ok again. I suspect its something to do with my wifes wash as after she...

Had a look at the valve there is an elbow on both hot and cold and then they head skywards within the cavity wall so I will try and trace them up above. thanks for your help.

I`ll have a look in the loft in case there is something up there, if not then at a loss where they could be. Mind you the house is 19 years old so maybe that was ok then. Juco12

Denso13, Sorry if I didnt explain properly, I know where the valves are to switch off the water, I was just trying to cover my tracks in the event of screwing this up or coming across some other problem and I could then cap the flow to the shower and turn the mains back on. juco12

Yes it is the service kit I am going to get for the cartridge gravity feed. But just in case it doesnt repair then I need to know how to cap the water. The problem with the shower is it wont turn off (I just blocked the end of the shower hose to stop the flow) Also looking for confirmation...

Can someone guide me through the next few steps for this Mira mixer shower. In the picture below I need to take out the `brass section` and then cap the water supply in order to repair it. I have stripped the above as far back as in the picture below. Would I be correct in assuming that I...