hi all the core plug at the back has split was just trying to find out if i had to take the engine out or has some one ever change one in place not much room to move at the back
cheers for any help
hello need to render the inside of the buliders opening had to take out a lot of brick to get the catchment space for the fire anybody no what sand and cement to use cheers for any help
thanks for all the replys was looking more to the anton sprint v2 kit as i wanted the hole lot in one go just looks like am going to have to dig deep now cheers again for the info
has any one got any ideas on a good flue gas analyser got two in mind
TPI 712 or
ANTON SPRINT V model
am after an all in one and any advice would be much appreciated as its a big expense cheers all
How hot is the shower getting, and you said the shower had filters try removing them to see if flow increase and also did you put any of the flow restrictors in instead of a filter
and have you put isolation valves in or gate valves
After reading all that my minds an unvented cylinder about to blow. Worcester and vailliant are good boilers can not comment on DD chose don’t know the boiler. Unvented cylinders and combi's are not that dissimilar i.e. what you put in is wot you get out. so check the flow rates and what the...
did you put a double check valve or none return valve in with the new tap.
how did you turn your hot water off to change tap the gate valve may not of opened fully is the rest of the house ok
I think the horizontal max flue length is 3 m on the cdi 28. How long dose it take to switch off/ how fast is the light flashing and do you have to reset each time
i would get your thermocouple replaced anyway you said you bent it towards the flame. that’s all part of the safety devices of the boiler and are set at distances so if the flame lifts it shuts the main gas off. And I think the 80 is a negative pressure fan so unlikely to be blowing the pilot out