Search results

cheers namsag. cleaned the impellor. but i think the wd40 helped to swim the muck into the bearings. and i was wondering wether or not it it would be a pig to rebuild if i stripped it. in the past i would just order a new one. but the customer is a bit short of dough. and i would like to try...

anyone stripped and cleaned a j and s fan, the bearings on this one are sticking with crud wd40 does not work.

tap it out gently with a big lump hammer. then buy a new one as you will have found it cannot be done. instead pack out the cistern from the wall

if its not the expansion vessl or the filling loop passing then it most likely is the domestic plate heat exchanger

Rember a bbu is two appliances innit so therefore work out are we over 7k per room what is the adventitious.think.extra ventilation maybe. Hard to say when you are not there

Fitted many an alpha never had a comeback or anything but reccommends dear but good and very quiet, said to my mate fire it up then my mate stated its been running for five mins I am a bit mutton due to age, V impressed with them. twot then said are you going to brick up the flue outside...

I used to install for servowarm eons ago and yes the boilers were crap with a capital crap But they had a good sales team of truth deniables. Still where I was they had s/hot surveyor made sure you had everything you needed but no more tight t4wt you would be lucky if you had a socket and...

one of those so called neutrals may be an unflagged live ie a return from a stat, or some other switching device

the drill must be able to hammer without rotating

why alpha

vokera compact fires then goes to lockout after two mins and will not reset whatever the position of the summer winter resetoff switch. even switching off at the spur does`nt help, the red light stays on even in the reset off position anybody got any ideas before I buy a control board, it...