Search results

Would very much appreciate it if yiu could let me have sight of the abovem- dishwasher not filling or washing -arms not moving - test procedure gets 011 (end/rinse/salt leds). Thanks

and stopping oven from working. Followed tip in this post and replaced capacitor and lo and behold I have avoided spending £600 on a new oven MANY MANY Thanks !!

You must have the same machine - that is the service number on mine....I will take the panel apart later today or tomorrow and have a look at what is going on with the knob/panel. Mike

Hi, Zipper, thanks for posting. 1. The problem is intermittent. 2. The machine can start a wash without problems but the rinse aid LED can flicker off and on even though he rinse aid dispenser is full. 3. The LED that sometimes flashes for whole or even part of the wash cycle is the one...

A few months ago I had a problem with the salt light erroneously coming on and now the rinse aid light is doing the same - the dispenser unit is full of rinse aid but the light stays on ... unless I wiggle the control knob. I am also geting continuos flashing of the first green LED but none...

I gave the salt box a very good stir with the handle of a wooden spoon, then gave the top side of the salt box housing a series of sharp taps with the same wooden spoon handle and thus far all ok. If problem comes back i will take it apart. Thanks cakeman for your comments

Thanks Pete Whilst I was awaiting a response from DIYNOT I found an email address for Mira tech support and sent them the same question. Their reply is pasted..... "Dear Sir, Thank you for your recent email. As I am unaware if the pipework enters the inter manifold from the top or the...

As I am going to retile the bathroom I need to remove the shower pump I installed some years ago. The hot and cold inside the shower pump fit into a plastic housing which has some form of locking collar. I have obtained a removal tool from the manufacturer but there are no instructions for...

The cables should be a push fit - no sodlering should be required. The smooth one is the suspect one.......... The test meter works without electricity - it has a small battery inside which sends a low voltage (9V) signal through any circuit to which the 2 leads are connected - and the buzzer...

Could you buy a cheap test meter - the kind that has a continuity buzzer built in? Then you could remove the electrical connections from the cut outs and test for continuity (i.e. closed circuit and good ! ) without removing them from the machine. Easy to do and the meter is always useful...

The two little button things are safety cut outs which are designed to prevent the dryer catching fire if it overheats. I have since learned that the most common cause for these to fail is when the door is opened halfway through a drying cycle " to see if things are dry" without moving the...

Doing this one for a friend. Indesit IS70C tumble dryer not getting hot. Have had the back off and the elements look ok. The thermostats above the elements give a closed circuit reading when using a test meter. I presume these are safety cutouts ? Update = when i checked the thermostats...