Search results

Just to let you know guys I Took the box down and exchanged it after a bit of a battle , Refitted the new one and it works perfect , Same wires , Same Wiring , Thanks To all for your help !!! Steve

Tried that No Go , still No stobe Thanks Again Steve

O.K Breezer I have run the strobe - Direct to the battery - Now And still Nothing , I have tried it with the strobe in test mode and without , I have replaced the 6 core cable from panel to bell box and have tested it fully for continuity All o.k . I will list the connections below but i,m sure...

Just to check one thing is the Strobe + Permanently Live Then ??? In the Bell Box Thanks

O.K Ive tested the strobe direct to the board in the bell box and it works , Ive tested the output from the panel and yes that works , Getting 12 volts when the strobe is activated , Ive tested the wire from the Strobe - in the Panel To the Strobe - In the Bell box and that is o.k . I have also...

Thanks Breezer i,ll try that , I,m sure my colours are right though , I,ll Post My Findings , Just to confirm One thing , The Strobe Uses the minus - So i Connect the Other Side To The 12 Volt Supply To The Sensors Is That Right thanks Again steve

Thanks Breezer For Your Quick Reply , Yes everything else works , Both Green And red lights , Do I just put a 12v + & - To The Strobe + & - In The Bell Box ?? Thank you Again Steve

Hi all New To The Forum , I have Installed A Few Optima Panels for freinds and family so i,m not quite a total Novice , I have just put a optima 8 in and wired it up but i can,t get the strobe to run, I have wired it from Strobe - to Strobe - and left the Strobe + not connected as usual, I,m...