basin waste trap

Hi we're getting our floor tiles done in the downstairs bathroom soon and we wanted to replace the basin with a corner one, but the waste pipe is a problem. Is it possible? without having to cut a hole through the middle? Corner Unit

I need to fit a new waste to a basin after removing an old one that was fitted (poorly) with silicone. I removed all lumpy bits of silicone and most of the the finer bits with silicone remover, but there is still some silicone bits left that I can't get out. What are my best options for getting...

I am fitting an Armitage Shanks bathroom basin and Grohe bidet. Both have outlets with lever operated plug mechanisms that screw onto the outet. The lever operated mechnisms have NF and EN274 stamped on them. They appear to be standard 32mm fittings but the outlet size is slightly too small by...

The background: installing understairs WC wall is adjoining neighbours so drainage to run out to other side of house (about 4.5m to external wall, 6m to 4" stack) hanging sink with this trap https://www.victorianplumbing.co.uk/round-modern-chrome-basin-bottle-trap-tube-to-floor-pipe-set...

Hi, I've bought a chrome basin waste but it says it's 35mm OD, which i don't think a normal 1 1/4" McAlpine compression will fit. Does anybody know connector i require? After posting, the chrome pipe will be through the floor, so just need a plastic connector, not a chrome one. Product...

Hi, so I've fitted a new waste with one of these seal kits - http://www.diy.com/departments/plumbsure-plastic-rubber-basin-sealer-set-of-1/178380_BQ.prd# and it's been pushed up / tightened, but there doesn't seem to be enough thread left on the waste to tighten the trap enough to make a good...