Hi there,
Another set of questions that someone will hopefully answer.
I’m planning a domestic ground floor renovation incorporating wet UFH.
The build up consists of:
Damp proof membrane over existing concrete floor
20mm Low profile boards with 16mm pipes - either EPS or XPS 300 kPa - no foil...
I'm planning to fit a wet system underfloor heating on my ground floor. So need some advice please:
The floor is timber suspended as shown below. The height of the gap below the joists is about 500mm. The joists themselves are 4'x2' (100mmx50mm).
I plan to:
- use battens on either side of the...
I’m planning on installing electrical underfloor heating in a wetroom, which is floorboards with thin ply over the top. So I have a 3a fused spur outside the bathroom my question is,
How would I go about getting the cold cable and thermostat to the location outside of the bathroom as the room is...