Morning all when the kitchen mixer hot tap is turned on then off a banging noise occurs in the bathroom upstairs, all the pipes have been refixed, clipped etc, sometimes does it with the hot and cold tap in bathroom is turned on then off aswell, if I drain the hot and cold water this stops for a week , then starts again. Someone has suggested fitting a water hammer device to the cold inlet near the boiler your expertise is needed all thank you
Banging noise when hot and cold taps turned on then off
- Thread starter Fizza
- Start date
Sponsored Links
Do you have mains fed hot and cold water? Via an unvented cylinder?
If yes, are the hot and cold balanced?
Has this always been present or just begun recently. One bang or several?
Has the UV cylinder ever been serviced?
If a combi, then all that can be suggested, over this media, is check clipping and insulation and, yes, consider a hammer arrestor on the cold main.
If yes, are the hot and cold balanced?
Has this always been present or just begun recently. One bang or several?
Has the UV cylinder ever been serviced?
If a combi, then all that can be suggested, over this media, is check clipping and insulation and, yes, consider a hammer arrestor on the cold main.
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
Sponsored Links
