All sorts of problems with CH and hot water
at the moment can only get adequate hot water for a bath if we switch Ch off 45 mins before
2 or 3 rad's upstairs hot
the rest either very luke warm or stone cold
have:-
replaced pump
replaced diverter
replaced stat on cylinder
flushed all rad's outside,twice
washed out the cylinder
plenty of water in header tank
I thought it was sludge, but last time it was done there wasnt much to show
can you tell me the exact sequence for bleeding/balancing rad's
i.e. i am intending one closing all the valves down and srting one by one to try and get hot.
do I close both valves down?
do i run CH when going round bleeding the rad's?
at the moment can only get adequate hot water for a bath if we switch Ch off 45 mins before
2 or 3 rad's upstairs hot
the rest either very luke warm or stone cold
have:-
replaced pump
replaced diverter
replaced stat on cylinder
flushed all rad's outside,twice
washed out the cylinder
plenty of water in header tank
I thought it was sludge, but last time it was done there wasnt much to show
can you tell me the exact sequence for bleeding/balancing rad's
i.e. i am intending one closing all the valves down and srting one by one to try and get hot.
do I close both valves down?
do i run CH when going round bleeding the rad's?
