When machine is operated normally water splashes out from both bottom right and bottom left corners of door. There is a gap between the main door/tub seal and the seal along the bottom of the door. The water is splashing out between the door and the tub body at the point between these seals. Is this a problem with the seals or is it perhaps because the tub is over filling? Any other ideas please?
Hotpoint Aquarius FDW60P Dishwasher Leak
- Thread starter notso
- Start date
Sponsored Links
- Joined
- 30 Apr 2008
- Messages
- 6,137
- Reaction score
- 1,044
- Country
check the spray arms are not split on the seams. also do you use 3 in 1 and rinse aid if so dont it causes overfoaming .remove top basket and at the back centre of the tub is a plastic nut undo and see it the rubber inside is split.
Thanks for that. I checked seams and bottom arm had slight split. Held it together with rubber bands as a temporary measure just to try it. Machine has now gone through full cycle without a leak!! It's obviously a simple thing but I think you're brilliant for signposting it. Thank you very much indeed.
Sponsored Links
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
