The only place I can relocate a vent pipe (leading to the F&E tank) is off a vertical section of 28 mm pipe at the rear of my wood pellet boiler just before the pump in the flow. To do this means inserting a T followed by a swept bend. This will be the only bend in the pipe apart from the one at the top where the pipe enters the top of the F&E tank. Will this be ok?
Is it ok to have a second bend in a vent pipe?
- Thread starter GoferBlue1947
- Start date
Sponsored Links
Muggles - thank you for your reply. OK, so I have to introduce a horizontal run of pipework into the system. Would the following work (I know it looks a bit convoluted but I am constrained by the existing layout)?
View media item 91856
Thanks.
Gofer
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
Sponsored Links
