Hi all
My customer asked me to lift some porcelain(?) tiles/slabs in his garden so that the electrician could run some cables. They came up fairly easily. I am guessing that they were initally laid on a fairly dry sand and cement mix.
I applied some sbr to the substrate and then used some CT1 to glue the tiles down. The CT1 has stuck to the tiles but over time has come away from the substrate.
What is the best way to stick them back without raising the overall height?
Admittedly the ground was wet/damp when I applied the CT1 but all seemed fine for a week.
My customer asked me to lift some porcelain(?) tiles/slabs in his garden so that the electrician could run some cables. They came up fairly easily. I am guessing that they were initally laid on a fairly dry sand and cement mix.
I applied some sbr to the substrate and then used some CT1 to glue the tiles down. The CT1 has stuck to the tiles but over time has come away from the substrate.
What is the best way to stick them back without raising the overall height?
Admittedly the ground was wet/damp when I applied the CT1 but all seemed fine for a week.
