Hello,
I want to set up extraction for my small workshop. My machines are as follows
· Hammer N4400 Bandsaw – with 120mm port
· Makita LS1013L Compound Mitre saw
· Trend router table
· Pillar Drill
I’m considering buying this extractor :
http://www.recordpower.co.uk/product/150l-2000w-compact-wall-mounted-extractor-4-inlet#.Vqn4RvmLSM9
This will be about 3m from the bandsaw . Here is a diagram of the shop. Because of space constraints / configuration – machines cannot change position.
I’d be really greatful for advice as to the best way to step-up from the 4’’ extractor to the 120mm/ 5’’ bandsaw. Or do I use a reducer at the bandsaw port to achieve this?
And then down to 2 ½ ‘’ for the rest of the machines.
As well as any recommendations on what specific ducting kit to purchase.
I’m more interested in a straighforward set up and will pay a litlle extra for this.
Thanks, Paul
I want to set up extraction for my small workshop. My machines are as follows
· Hammer N4400 Bandsaw – with 120mm port
· Makita LS1013L Compound Mitre saw
· Trend router table
· Pillar Drill
I’m considering buying this extractor :
http://www.recordpower.co.uk/product/150l-2000w-compact-wall-mounted-extractor-4-inlet#.Vqn4RvmLSM9
This will be about 3m from the bandsaw . Here is a diagram of the shop. Because of space constraints / configuration – machines cannot change position.
I’d be really greatful for advice as to the best way to step-up from the 4’’ extractor to the 120mm/ 5’’ bandsaw. Or do I use a reducer at the bandsaw port to achieve this?
And then down to 2 ½ ‘’ for the rest of the machines.
As well as any recommendations on what specific ducting kit to purchase.
I’m more interested in a straighforward set up and will pay a litlle extra for this.
Thanks, Paul
