have looked through previous posts and think the prob maybe water level sensor or brushes, the washer fills, i can hear it heating but wont move on in programme will drain but not spin, have tried to take a look but unable to split the cabinet in two seems to be attached at the bottom sides but how do i get the cabinet open ? any advice would be much appreciated thanks.
zanussi FLS1185QW washer filling but not mving on in program
- Thread starter lindal35
- Start date
hi-remove lid,undo 2 screws holdingback panel,at bottom of machine there is 2 white bungs.remove these and there are 2 screws underneath, remove these and the rear half of the casing comes off
Thanks very much replaced brushes ourselves and up and running.
Linda
Linda
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local