For the installation and removal of the lockring on both Shimano HG and SRAM cassettes, when used together with a 24mm spanner or socket and a cassette holding tool or chain whip. It can also be used on Centerlock brake discs that use a 12-spline (Ø23.4mm)...

Badly adjusted or loose cone nuts can cause unnecessary wear and damage to both the wheel bearings and inner hub components. These super slim cone spanners allow for the cone nuts to be tightened hard up against the axle lock nuts so that they don't then...

Ideal for both the keen home or workshop mechanic, this spoke tension gauge belongs next to any wheel truing stand. For use when building, rebuilding, or truing a bicycle wheel, it accurately measures the tension of each spoke together with the relative...

These L shaped Star* Keys each feature a long shaft with a ball end tip allowing for greater access. The set includes sizes T10, T15, T20, T25, T27, T30, T40, T45, T50, which are colour coded allowing for quick and easy identification of size, helping...

This freewheel remover not only a fits Shimano freewheels, allowing for their quick and easy removal so that wheel bearings and axles can be accessed, but it is also suitable for use on Campagnolo Cassette lockrings when used with a holding tool or chain...

For use when having to guide new cables through an internally routed frame, this kit uses magnets to make light work of a task that can be both time-consuming and frustrating. It comes supplied with adaptors to fit inner gear & brake cables, Shimano Di2...

This chain wear indicator gauge should be used periodically to measure how much a chain has worn and stretched, ensuring it can then be replaced before it has caused any additional wear to the components that it runs on. A worn chain can be noisy, cause...

A wheel alignment gauge (dishing tool), is essential for ensuring the wheel sits correctly in the frame or forks by allowing you to check that the rim is centred between the locking nuts on either side of the hub. Ideal for use when wheel building or...

Disc brake tool combining two different functions to ensure that brake rotors can run freely and quietly through the caliper. At one end is a rotor truing fork, with two different length slots allowing for different degrees of leverage to be applied to...

Typically 5mm thinner than a regular spanner, cone nut spanners slide between the hub and the axle locking nut, onto the cone nut to allow for the hub bearings to be correctly adjusted. This set of cone nut spanners is ideal for use by both the home or...