These tools produce the same type of joint & use the same components as the combination PSC sets. D 46 mm D2 42 mm C 15 mm C2 6.3 mm B 22 mm R 10 mm Shank Diameter 1/2 inch Timber thickness min. 21 mm Timber thickness max. 26.5 mm

Allows templates to be placed either on top or the bottom of the material, for ease of routing.

Ideally suited for cutting radiused edges at speed, as a side fence can be dispensed with. C 9/16 inch C 14.3 mm D 22.2 mm OL 64.2 mm B 9.5 mm R 6.3 mm Overall length 64 mm Shank Diameter 1/4 inch

For 4.0mm thick strip the TR42 is for 15.0mm wide intumescent strip. D 40 mm C 15 mm B 32 mm E 4 mm Shank Diameter 1/2 inch Fire check 45 minutes

By raising the cutter, the top quirk is removed. Alternative bearing Refs. B95A & B127A. D 35 mm C 13.5 mm B 12.7 mm R 4 mm Overall length 65 mm Shank Diameter 1/4 inch

Replacement blade for the Trend QUADX1/2TC Quad groover set

The glazing bar ovolo cutter is bearing guided to speed setting-up and to enable curved frames to be moulded. D 28 mm C 19 mm B 12.7 mm R 10 mm Overall length 70.5 mm Shank Diameter 1/4 inch

Cuts cleanly without feather edging. D 14.5 mm C 12.5 mm C2 14 mm A 60 degrees Shank Diameter 1/4 inch

These cutters are for use with the Nutool and Axminster Power Tool Centre Dovetail Jigs. D 15 mm C 13.5 mm Overall length 63 mm B 12.7 mm A 104 degrees Shank Diameter 1/4 inch

Used for trimming plastic or plywood overlays. D 1/2 inch D 12.7 mm C 1 inch C 25.4 mm B 12.7 mm A 90 degrees Overall length 79.5 mm Shank Diameter 1/2 inch