- Joined
- 10 Apr 2022
- Messages
- 31
- Reaction score
- 0
- Country
Hi I have a Hive HW/CH to replace my Honeywell ST699 programmer and thermostat. I have a conventional boiler and thermostat controlled hot water tank in the airing cupboard. Typical stuff.
I understand I need to bridge the live and live switch cables to bypass the old thermostat to enable the Hive to take control of thermostat functions. That's quite easy and will probably just bridge and then push carefully into the wall cavity for future use of necessary.
However...could anyone please give me some directions of how they think I can transfer the old ST699 programmer to the Hive programmer. Am I doomed to get my multimeter out and trace all the wires from the wiring loom into the ST699 programmer to identity where they should all go into the Hive?
Photos attached and renamed for reference! Thanks
I understand I need to bridge the live and live switch cables to bypass the old thermostat to enable the Hive to take control of thermostat functions. That's quite easy and will probably just bridge and then push carefully into the wall cavity for future use of necessary.
However...could anyone please give me some directions of how they think I can transfer the old ST699 programmer to the Hive programmer. Am I doomed to get my multimeter out and trace all the wires from the wiring loom into the ST699 programmer to identity where they should all go into the Hive?
Photos attached and renamed for reference! Thanks