Recent content by 680312

hi,ive had a wall knocked down and an rsj fitted.i'm wanting to extend the wall undetr the rsby 1 brick width and have fitted a steel channel from rsj to floor.I was going to tie it in with the existing wall by removing half a brick but the building inspector said to use a wall tie kit.Will it...

hopefully i'm not getting paranoid but what happens to the flux inside the gas pipe?have heard stories that it may corrode it over time

the guy came today and heated the pipe up and everything working fine,said it must have been flux.

the guy did seem to use a lot of flux as i had to clean it off.He also used solder fittings which he must have added quite abit extra as the pipe is coated with a good inch below fitting

had it altered by a gas safe plumber.He said,over the phone,that it would have a better supply than previously.He's coming out to take a look tomorrow

is it possible for a soldered joint to partially block a gas pipe reducing pressure?my cooker has a very limited gas pressure and will only give a very low flame.A t was taken from the boiler supply and now theres hardly any pressure.Boiler works fine

hi,i'm going to put up a new fence up soon and have ordered kpost(like postcrete) to fix the concrete posts in.i,m going fairly deep and will need at least 2 bags per post.Ive read you put the water in first and then mix but have also read if you add too much water it can weaken the mix.i'm just...

Havent got rcds only rewireable fuses.i know the gas meter goes to the earth terminal and the ring and lightining circuit but nothing else.

Ive noticed my boilers pipes are crossed bonded but when looking further the earth wire is cut and doesnt go anywhere.there is a fused switch to the boiler and was wondering if it was ok to to wire it to the earth in there as i cant get it back to the consumer unit without ripping the house apart

is it ok to earth bond pipework to a socket instead of running it back to a consumer unit?

just rang corgi up who can give you a copy of your completion certificate and they say it was never registered!

i never recieved a certificate and the plumber who installed it retired a bit back.am worried this will affect the house sale

hi,i had my boiler installed in 2006 and dont seem to have a completion certificate.The thing is i've got my house up for sale and recieved a letter from the solicitors saying i need one and if i havent got one to obtain one from the relevant competent persons scheme listed on...

Is there anyway you can test the auto air vent is working on a combi? i can hear air in the boiler as it fires up to heat the water but disappears after a few seconds.i'm sure the the vent isnt removing the air

its an ideal isar.