Recent content by ccw123

Hello, We're building a single storey 6.5m x 6.5m summerhouse with a slated roof and have to span 3.9m twice. One side has has to support a gable consisiting of approx. 60, 100mm blocks and the other just has to pick up the rafters. We can get our hands on two 152x152x37 steels and wondered...

Evening, I'm digging the foundations for a 5.5m x 5m single storey summerhouse constructed in 4x2, osb, then redwood cladding with a pitched slated roof. I was going to make the strip footings 600mm wide x 600 ish deep (depending on the quality of the sub soil), but looking at it 2ft wide...

Morning, I have just removed two 700mm square double convector rads from my living room and replaced then with a single 2000mm x 400mm double. The rad is in the same position as one of the old ones and uses the same, although modified, 15mm pipe, which is branched off 22mm. I am getting no...

Hi Baxipoti, I replaced the diverter valve with no luck then the P.C.B. and what do you know I'm only warm. I see why you boys do it it makes you feel like a man,me missus thinks I'm a genius. Thanks for your help. Merry Christmas.

Yes I have radiators which I bled this afternoon. I am racking my brain for anything obvious but I can't think of anything. I would be more than happy if it was just that I was being a muppet cos I'm freezing. Thanks very much for taking the time to advise. Cheers, Dave

can you elaborate?

the link wire is red, behind the blanking plate is a terminal block with a blue wire to the first terminal a red to the second and two black ones to each end of the third

Hi BaxiPoti, In your last post did you mean that the primary flow microswitch is not making contact? Is the primary flow ch or dhw?

No

no

I do realise that the link you refer to is next to the earth terminal by the way. cheers.

I tried to reset just in case a miracle occurred.

the link is fine.

None of the fault neons are on only the mains power. Hot water and flame indicator when DHW is demanded. I'll check the earth link.

Good evening, My 105e DHW is fine but CH is none existent. None of the failure lights are on and the pressure is constant at 1.5 bar. The pushrods on the diverter both engage the micro switches, so I guess the diaphrams are ok(?), but no CH. The boiler will not reset when I turn the switch...