Thanks. Yea in hindsight I should have used something to get between wall and the desk but could not imagine they would have stuck the desk frame to the wall as well as screwing it into the wall and skirting boards! What a disaster. Sounds like a simple plaster job then.
Hello. We moved recently and the previous owners decided to glue a desk good and proper to the wall. With little persuasion it has pulled off massive chunks of plaster. The attached photo is the worst bit. Do you think I can repair this with filler or is something more drastic needed?
Who...
Hi,
We've just moved house and after a few days the cistern has stopped filling. I'm not that familiar with these dual flush systems and don't really know where to start.
There is a tiny slow drop of water filling the cistern but that's it and nothing happens when I lift up the fill valve to...
Hi - i am also wondering about this. I have a corner that has been chipped, and its plaster that has been covered in paper. I'm wondering if there is some sort of tape you can buy to reinforce the corner and paint over it?
thanks!
Hi,
I've also measured up my glass as 26mm.
I.e. the PVC unit being 62mm and the space between the plastic and glass on each side being 18mm on both sides.
Is it likely that the PVC unit is actually 60mm, meaning the glass unit is 24mm?
Should I go for 24mm, and what happens if this is...
No not the roof, well it is the roof to the kitchen which is extended out the back. The soil travels further up the wall to the side of the bathroom.
The branch off the soil to the left is the sink waste, and thst is the joint that has failed. The branch pulls away, but the existing boss is...
Hi,
I have a 40mm waste going into our 110mm soil stack. The connection has failed and i want to replace it.
Ive been to the plumbers mechant and got a new 40mm boss connector. The opening on the stack is 60mm, but that is the exact size of the boss connector and so it will not fit in the...
hi terry - the boiler outlet is close by but its not connected - yes its hanging lose as i pulled it apart to evaluate it - and the seal has failed. hopefully i new boss will sort it!
o kthanks - i was just checking that i didnt have a leak somewhere that i should be worried about. i will try to sort out the new boss connector. thank you john!