Recent content by devon scouse

Many thanks for quick reply Andy They re pressured vessel. All visible fitting have being nipped again. Losing about .4bar a day

Hi Looking for some advice on problem with Worcester 24 losing pressure. Boiler serviced in September expansion vessel re pressured and pressure relief valve changed by BG. Now into December and boiler losing pressure again. Recalled BG on Friday who replaced heat exchanger and pressured...

I will go with the above poster. If not sure how to change have a look at this http://www.youtube.com/watch?v=_jlD5gnh9jw&feature=fvsr

Hi Discovered on Thursday that I had a burst water main pipe between water meter and stop cock so yes it is my responsibility. Contacted insurance company who said they would get someone out Monday and repair it. Its the old black pipe. To me this seems a waste of time to come and repair it...

Thanks for your replies. Sorry should of said to connect cable to ariel end.

Just about to put an new ariel up to get freeview. Just a query about the wiring. Do I wrap the outer wire around outer plastic and clamp on top of it. Or trim it back under the outer plastic. Happy were the inner wire goes. Many Thanks

Hi This maybe a dumb question, just installed radiator in hallway that is slightly smaller than original one. When I shorten the pipe is their any reason why I cannot join them using an isolating valve? Many Thanks

Thanks for your reply Socket is on spur from ring final. Socket I intend to use has two sets of wire going into it. Will be using twin and earth. It will be in stud wall less than 50mm from surface. Yes socket is protected by 30m RCD.

Can I run a fused spur from a socket to operate a wall light? Many Thanks

Had same problem with my shower. PRD held in by 2 screws make sure you isolate water and electric. Got replacement PRD from http://www.shower-spares.co.uk/gainsborough_showers.html for less than £10

Have you tried Vaillant directly I have cover with them and it is cheaper than what you have ben quoted. It also includes boiler service

Had something similar to you. I cut a couple of threads off plastic inlet valve and replaced fibre washer with rubber washer. This seemed to solve my leak.

sdl

Many thanks for your speedy reply is it an easy enough job to replace i.e out with the old in with new. Have located one on web site it looks like one type fits all