Recent content by JoelyP

:(

ok so i removed the crumbling ledge and dug the cavity out down about 2 bricks, is this ok? just want to be sure that pushing dpc into the cavity curving up to the dpc of the floor then filling with quick set cement is acceptable practice and wont cause any problems in the future. also, will i...

update: another gas engineer came out today and after i gave him all the info and mentioning suggestions offered on here he found that the flame sensor/ignition connector had been pushed in too far, so as many of you mentioned on here, was close enough to arc and ignite but no continuity to send...

I am about to lay laminate wood flooring in my lounge/diner but have stumbled across a problem after lifting the carpet. The patio doors are fitted on the outer brick work leaving the cavity exposed. When this flooring was layed the was bridged up to the bottom of the door frame but still left...

any advice?

bit more info: i've just timed it and its between 3 and 4 seconds... its is the same time every time. once the boiler is reset, the water pump works normally. it spools up when the boiler is starting its firing sequence, then the boiler fires up... tick tock tick tock, shuts down and the...

Hi there, I've just spent the last couple of hours trawling through the many threads regarding the lovely reliable suprima boilers! I called a local gasman out t'other week to do a routine service on our boiler as we hadn't had it done since we moved in and it had been a year. Once he had...

hi peeps, whats the best product to use to prevent damage between the toilet and porcelain floor tiles? i have a load of dc785 to use but i thought id double check. was planning on setting it in this and let it go off, then screw the pan down into the plastic brackets attached to the tile... is...

Hi All, I am tiling a wooden floor in my bathroom (joist span 40mm, board thickness 16mm - small 2m squared area). I am putting down 6mm Hardibacker boards in preparation for waterproof matting and tiles with bal rapidset flexible. My local topps tiles told me to simply screw the board...

I agree that the seal would potentially not be as good and ideally, that is the way i wanted to do it, but with this end panel its making me think twice. It is a shower bath in the p shape and the panel is definately the complete length unfortunately... any advice welcomed.

Hi all... As per the tiling guide, it has always been my intention to tile up to my new bath and silicon seal between the tile and the bath deck... however, as the moulded side panel extends the complete length of the bath, the tiles down the side would then prevent the side panel from fitting...

hi richard, just to throw a spanner in the works, what are your opinions on pressurised hot water systems? a friend of mine has just suggested, as an option instead of a noisy pump, to put a mains fed pressurised vessel in the system to give my hot water a mains header pressure.

do you know if the st pumps come with a plug? it says 'prewired - yes' but i assume that just means from the pump itself. just need to decide now whether to go for the 2bar or the 3bar

ill try the one i have and see how i get on but i will bare that hudson reed one in mind. i've got a hudson reed deck mounted shower head for the mrs' hair and the dogs!.. bloody expensive stuff! out of curiosity, you say you have your whole house supplied with the sally and only turn it on...

according to the website yes: http://www.ergonomicdesigns.co.uk/SH-316-8_Mirror_Shower_Head_With_Neoprene_Outlets.html