Search results

is there a dual open spanner for the locking nut and flexit hose connector for cistern fill valve, space for access is very tight, tried an adjustable its to long, what id like ideally is a thin dual open spanner that will fit either nut, i was going to diy box spanners with a grind out.

i lost the screws that hold down the plastic part that sits on top of the starter, its the part with the two holes, one for the petrol tank lid and where the starter cable comes out, its purely cosmetic to make the mower look better and covers the metal parts i assume, not sure what size screws...

we use a danfoss 841 school bell timer system, lately we have noticed all the bells are not rinnging loud enough and seem a few seconds shorter than they used to be when ringing, what could be the fault of all of them sounding dull and ringing for a shorter time, than they used to, we had some...

i sanded my pine wood living room floor and used fiddes hardwax oil to finish i had my house rewired and the electricians ruined to floor, as they did not use dust sheets, they had to chase the walls for new wiring, and the walls have black mortar inside, this went all over the floors and it...

Qualcast quad trak 45 petrol mower, the chassis has rusted and split my question is could i take the engine off the broken mower and put it on a Qualcast 40P chassis

i have this timswitch, i have been trying to set it to go on for two hrs every morning but it seems to want a second and third time in the same day to go on and off, i just want once, i notice it has auto, allday,24hrs,off please can someone give me a simple walkthrough, i want it to go off...

i have an ariston titanium plus water heater brand new installation, it stopped working and just trips it fuse in main fuse box the unit will not go on but just tripe fuse

has anyone tried using different guage line for this strimmer, as the ones that your supposed to use snap to easy, i used to have an older model similar black n decker and i could use any line i wanted tight fit but it worked fine. havent tried it on this model, reason because i can pick up...

how do i remove the pump from my old hotpoint dwf32 dishwasher to install a new one, i have noticed the top spray arm is not spinning. i have taken arm off cleaned out any debris, but there was none so im assumong its the pump.

i bought 5ltr of magnolia Vinyl Silk, but its more of a white pastel how can i make it a bit darker yellowish

my hotpoint dwf32 dishwasher doesnt fully drain out, there about and inch of water still in machine after it pumps out, i cannot see any blockage's i have taken the lest side panel off and its pretty clear, if it the pump failing, exactly where is the pump located in the machine, the back does...

i have a russel hobs kettle model 10828 but it has screws that i dont have a driver for, its not a philips posi or a hex or torx

is it possible to mend a a flame failure device, without having to replace complete unit. as there £70 to £80 pound

i have a hotpoint dishwasher dwf aquarius now and again when running it i can hear a pop and the power goes off in the house and i have to switch poer back on via fuse box. and when i turn on dishwasher it carries on working like nothings wrong, what could it be inside washer, what can i check...

i have noticed the plug on my dryer is getting very hot, in fact in melted the plug and i had to replace it, what could be the problem

my house was given a internal wall insulation pumped through holes made on exterior walls, i have noticed of late on the inside wall of my living room a damp patch just above skerting board, the roof was checked but nothing found, the damp does not come from above ie it doesnt seem to be a roof...

i have a denon dcd-685 hifi cd player lately the sound on any cd i play is starting to break up and distort new or old. im assuming the lens is failing as i took of lid and cleaned the lens with an ear bud, this made no difference should i try using some kind of fluid if so what chemical...

my old triton t80i has packed in, i have a seen a triton caselona on sale. will the entry point fittings be the same for the water inlet.