Advice o0n fitting Tand G round corners

[den9112]

Hi, i am fitting some TandG around a dining room wall and would like some tips on when it comes to the corners,do i purchase corner pieces for the job or just go up to the corner with the TandG. The wall is pretty good and even so i will be using adhesive rather than battons for fixing. Any help or advice would be apreciated .Thanks

 

[stephenf8542]

I'd go for angled beading,it'll help protect the corner from damage as well as a better finish

 

[JohnD]

internal corners or external corners?

 

[stephenf8542]

external unless the internal corners run off

 

[JohnD]

I was asking den9112

 

[big-all]

on externals providing the walls are parrallel and strait

i remove the tounge and back off the groove gives you nice little feature
if one or more off the timbers need scribing or tinkering you just reform the groove with a router and chamfering with a plane as the bearing on a router cutter will have nothing to run on

 

[den9112]

Thanks for the replys , it is internal corners .