Hi, you have helped me out in the past with my aquastream in a rented property that I have just done my 6 month inspection on. I noticed that there was a drip from the shower where the hose attaches to the body of the shower. Turns out that the hose adapter has a hairline split in it. I have took the unit apart and unfortunately during this process the wing on the bayonet fitting that holds the hose adapter onto the impeller body snapped off
Have managed to get this back water tight by cable tieing around the hose adapter to create a loop then tieing two straps around the valve body. This seems an adequate repair but I am still left with the split hose adapter. Do you carry this spare on board and are you near RM7 postcode today? Also do you know if you can get or have you got a spare pump impeller body. Dont need the motor only the plastic housing that has the bayonet wings on. I have seen the cost of the pump complete and probably couldn't justify paying that as the unit is 1997 vintage so probably coming to the end of its life so would go for a complete new unit. Whilst on the subject of a new unit are the MK2 or Mk3 whatever is the current model totally backwards compatible ie if I buy new is it just a case of pulling the old one of the wall? Assume I can use my old tranny or worst case using the wiring as this is buried behind the tiles.
Many thanks
Have managed to get this back water tight by cable tieing around the hose adapter to create a loop then tieing two straps around the valve body. This seems an adequate repair but I am still left with the split hose adapter. Do you carry this spare on board and are you near RM7 postcode today? Also do you know if you can get or have you got a spare pump impeller body. Dont need the motor only the plastic housing that has the bayonet wings on. I have seen the cost of the pump complete and probably couldn't justify paying that as the unit is 1997 vintage so probably coming to the end of its life so would go for a complete new unit. Whilst on the subject of a new unit are the MK2 or Mk3 whatever is the current model totally backwards compatible ie if I buy new is it just a case of pulling the old one of the wall? Assume I can use my old tranny or worst case using the wiring as this is buried behind the tiles.
Many thanks