Hi folks ...
Firstly, this is not strictly a plumbing question however I'm guessing there are loads of people on here who will be ablt to help with my question?
I have a alu tube with ID of 10mm that I need to bend slightly, I have seen internal bending springs on ebay and other sites which are pretty cheap but need to check exactly what I should be doing ... Do I need to heat up the pipe first and wont the spring just get jammed inside the pipe?
Thanks in advance!
Firstly, this is not strictly a plumbing question however I'm guessing there are loads of people on here who will be ablt to help with my question?
I have a alu tube with ID of 10mm that I need to bend slightly, I have seen internal bending springs on ebay and other sites which are pretty cheap but need to check exactly what I should be doing ... Do I need to heat up the pipe first and wont the spring just get jammed inside the pipe?
Thanks in advance!