I have recently replaced the main control board on the above Bosch and run
a couple of loads the last few days.
First couple were fine and I thought job done!
Guess I have been a bit unlucky though as the bearings seem to have collapsed during a wash today
(lump of plastic through to the drain filter) and now it sounds like an old iron gate....
I know these machines are of relatively poor quality relative to the german built machines,
but is it possible to get a replacement bearing kit for them?
Looking on the support site indicates the bearings may be not be available as seal parts are only shown for this model.
What do you think....landfill beckons or can it be fixed?
a couple of loads the last few days.
First couple were fine and I thought job done!
Guess I have been a bit unlucky though as the bearings seem to have collapsed during a wash today
(lump of plastic through to the drain filter) and now it sounds like an old iron gate....
I know these machines are of relatively poor quality relative to the german built machines,
but is it possible to get a replacement bearing kit for them?
Looking on the support site indicates the bearings may be not be available as seal parts are only shown for this model.
What do you think....landfill beckons or can it be fixed?