Does a standard 1/2" float valve take a standard tap connector?
I'm working in plastic push fit and just bought a JG angled fitting from Toolstation and the spigot in the fitting is too big to go into the 1/2" float valve.
Is the JG push fit a non-standard type?
Will I need to buy a normal angled solder tap fitting but will that fit?
Richard
I'm working in plastic push fit and just bought a JG angled fitting from Toolstation and the spigot in the fitting is too big to go into the 1/2" float valve.
Is the JG push fit a non-standard type?
Will I need to buy a normal angled solder tap fitting but will that fit?
Richard