hi, its to do with the copper cylinder in the hot press, recently i have noticed three small green marks just above the joint on the top of the cylinder just one spot of water has come out of one of them at the moment is there any thing i can fill the spots with or is it a case of getting a plumber to put a new one in, any one any ideas cheers
copper cylinder
- Thread starter hawthorns
- Start date
Sponsored Links
This sounds like a very old one without any foam insulation!
Better replaced with a modern efficient one and save heat!
A temporary repair can sometimes be made with araldite or solder but I would not advise that!
Tony
Better replaced with a modern efficient one and save heat!
A temporary repair can sometimes be made with araldite or solder but I would not advise that!
Tony
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
Sponsored Links
