My SCR receiver attached to the boiler has the red led illuminated constantly. I followed the instructions for commissioning the system, which somone else also said to do on another thread here. i.e. with the red led lit continuously, push the over ride button so the green led also illuminates. Then entering learn mode by pressing button 1 and 2 together, where the red led flashes for 2 second and goes out. Then the red and green leds are on together. I then replaced the batteries in the digistat starting with the right 2 batteries then the left 2 batteries.
However it is here that it says that the red led should flash for 7 seconds and then go out.
HOWEVER the red led remains on constantly on mine and i have done this numerous times.
Is there something i am missing out or has anyone experienced anything similar? Please help......
The only way i am able to control my heating is using the override button on the receiver. The thermostat doesnt appear to be acknowledged what so ever.
Should i just replace my system
However it is here that it says that the red led should flash for 7 seconds and then go out.
HOWEVER the red led remains on constantly on mine and i have done this numerous times.
Is there something i am missing out or has anyone experienced anything similar? Please help......
The only way i am able to control my heating is using the override button on the receiver. The thermostat doesnt appear to be acknowledged what so ever.
Should i just replace my system