Hi Hope someone can help.
If a gas installer cannot see the size of pipe feeding a gas cooker in the kitchen but then runs a t off the 15mm pipe that is visible by only a few feet to install a new gas ch system, what should he do to make sure the pipe is the right size for the 2 feeds?
Heres the situation.
Gas meter on front wall of house. Gas fire in lounge, 10ft from meter. Gas pipe goes under concrete floor another 30 ft into kitchen. 15mm pipe comes up from floor to gas cooker point. There is only a few feet of 15mm visible. This has been t off to supply new ch boiler runing 7 small rads no hot water.
Boiler seems to stuggle when all 3 gas appiances are on.
Pressure??
Any ideas please. I thing I've got a problem with the gas installer.
Regards
ha007
If a gas installer cannot see the size of pipe feeding a gas cooker in the kitchen but then runs a t off the 15mm pipe that is visible by only a few feet to install a new gas ch system, what should he do to make sure the pipe is the right size for the 2 feeds?
Heres the situation.
Gas meter on front wall of house. Gas fire in lounge, 10ft from meter. Gas pipe goes under concrete floor another 30 ft into kitchen. 15mm pipe comes up from floor to gas cooker point. There is only a few feet of 15mm visible. This has been t off to supply new ch boiler runing 7 small rads no hot water.
Boiler seems to stuggle when all 3 gas appiances are on.
Pressure??
Any ideas please. I thing I've got a problem with the gas installer.
Regards
ha007